Consumer product recalls

A cracked subframe may damage the front axle carrier and cause a loss of vehicle handling and control, increasing the risk of a crash.

Unexpected hard braking can increase the risk of a crash.

A missing recall registration card may result in an unregistered child seat, which can delay recall notification and increase the risk of injury.

The recalled water bottles can crack, causing a laceration hazard.

The stools can collapse or tip over while in use, posing serious fall and injury hazards to children.

The recalled BD Vision harnesses can degrade over time and fail to support the climber, posing a fall hazard resulting in serious injury or death.

Part of the teethers' safety snap clasp can detach, posing a choking hazard.

The heater's fan can fail to turn on and cause the unit to overheat and ignite, posing fire and burn hazards.

The recalled gates violate the federal safety regulations for expansion gates and expandable enclosures because a child's torso can fit through the opening between the gate and the floor, posing a risk of serious injury or death due to entrapment hazard.

The fork steerer tube on the recalled bicycles and framesets can crack, break, or separate during use, posing a fall hazard.

The lithium-ion batteries can overheat and ignite, posing a fire hazard to consumers.

An incorrect label may result in an improperly restrained child, increasing the risk of injury in a crash.

Battery failure can cause a loss of drive power, increasing the risk of a crash. Additionally, a battery short circuit increases the risk of a fire.

Control arm failure can cause a sudden loss of vehicle steering and control, increasing the risk of a crash.

The recalled Taylor Water Technologies reagent bottles sold with test kits contain sulfuric acid, which must be in child-resistant packaging, as required by the Poison Prevention Packaging Act (PPPA). The packaging for the bottle with sulfuric acid is not child resistant, posing a risk of chemical burns to the skin or eyes and internal corrosive burns, if ingested.

The recalled crib bumpers violate the federal crib bumper ban, posing a deadly suffocation hazard to infants. Padded crib bumpers are banned by the federal Safe Sleep for Babies Act.

The recalled children's bathrobes violate federal flammability regulations for children's sleepwear, posing a risk of burn injuries and death to children.

The recalled unassembled Deluxe Pit Kit slot cars violate the mandatory federal regulation for magnets because the magnets used to power the car are loose prior to assembly, posing an ingestion hazard to children. Assembled models do not pose this risk and are therefore not subject to this recall. When high-powered magnets are swallowed, the ingested magnets can attract each other, or another metal object, and become lodged in the digestive system. This can result in perforations, twisting and/or blockage of the intestines, infection, blood poisoning and death.

The recalled children's nightgowns, pajama sets and robes violate the federal flammability standards for children's sleepwear, posing a risk of serious burn injuries or death to children.

The metal contact in the switch mechanism of the Recon LT avalanche transceiver can corrode and cause the transceiver to malfunction. If this occurs, the device can turn off and make it impossible to locate a victim in an avalanche, which could result in serious injury or death.

The stroller fan's housing allows consumers' fingers to contact the fan's blade, posing a laceration injury hazard to small children.

The recalled baby loungers violate the federal safety regulations for Infant Sleep Products because the sleeping pad is too thick, posing a suffocation hazard; an infant could fall out of an enclosed opening at the sides of the lounger or become entrapped; and the sides are too low to contain the infant and the loungers do not have a stand, posing a fall hazard. These violations create an unsafe sleeping environment for infants.

The recalled high chairs pose a fatal suffocation risk because they were marketed, intended, or designed for infant sleep, and they have an incline angle greater than 10 degrees in violation of the federal Safe Sleep for Babies Act. In addition, the high chair poses a deadly entrapment hazard because the opening between the seat and tray is large enough that a child can become entrapped in it, which is a violation of the federal regulations for high chairs.

The recalled auto belay device can fail to retract, posing a fall hazard and risk of serious injury or death.

A fuse within the avalanche transceiver can be defective and cause power to drain from the battery, posing a risk of loss of emergency communication which could result in serious injury or death.

The wall sconce's electrical wires can become damaged at the adjustable joints, posing a risk of electric shock.

The recalled children’s pajama sets and robes violate the flammability regulations for children’s sleepwear, posing a risk of burn injuries and death to children.

The recalled combiner cables can malfunction when used with Nomad-series solar panels, posing a fire hazard.

The recalled pajamas violate the flammability regulations for children's sleepwear, posing a risk of burn injuries to children.

The boilers can release carbon monoxide (CO) due to delayed ignitions or component damage, posing a risk of serious injury or death.