Consumer product recalls

These mug's lid threads can shrink when exposed to heat and torque, causing the lid to detach during use, posing a burn hazard.

An air brake tube that bursts can result in a loss of braking ability, increasing the risk of a crash.

Damaged bearings can cause the wheel to separate and result in a loss of vehicle control, increasing the risk of a crash.

A detached raised air intake can fall off the vehicle and become a road hazard, increasing the risk of a crash.

The positive (+) battery terminal cover (red) can become damaged by the seat base, causing the positive (+) battery post to be exposed and contact nearby conductive components, resulting in an electrical short, posing a fire hazard.

The vehicles' passenger side seat belt anchor point can separate from the frame due to a defective weld on the bracket, posing an injury hazard to passengers from impact with a loose bracket or failure of the seatbelt during a crash.

The lithium-ion batteries in the recalled power banks can overheat, posing a fire hazard.

The mechanical internal locking plates can fail to align and allow unauthorized users to open the gun safes, posing a serious injury hazard and risk of death.

The oven gloves can fail to provide sufficient protection from heat, posing a burn hazard to consumers.

The plastic pins securing the LED light fixture can degrade, allowing the electrically charged LED board to come loose and contact items nearby that can catch fire, posing a fire hazard.

The flame can burn too high and cause the glass container to break, posing fire and laceration hazards.

The lithium-ion batteries in the recalled A3102 Anker Soundcore (black) and A3302 PowerConf S3 Bluetooth Speakers can overheat, posing a fire hazard.

Accidentally using power steering fluid as brake fluid can result in reduced braking performance and increase the risk of a crash.

A loss of anti-lock brakes, electronic stability control, or traction control can increase the risk of a crash.

In the event of a crash, the front harness may not restrain the child, increasing their risk of injury.

The spacing between some of the crib's slats is wider than allowed under the federal safety standard, posing an entrapment hazard to children.

The wall beds can detach from the wall and fall onto those nearby, posing serious impact and crush hazards.

The front fork of the recalled KickScooters can break, posing fall and injury hazards to the rider.

The recalled helmets do not comply with the retention system requirements of the mandatory federal safety regulations for bicycle helmets. The helmets can fail to protect the wearer in the event of a crash, posing a risk of head injury.

A natural gas leak in the presence of an ignition source increases the risk of a fire.

The fasteners can loosen and fall out, allowing the tow vehicle to detach from the pin box and increasing the risk of a crash.

An incorrect label and user guide may result in an improperly installed child seat, increasing the risk of injury in a crash.

A detached mount can become a road hazard, increasing the risk of a crash.

A loose or detached oil filter can allow oil to escape from the engine and contact the rear tire or road surface, increasing the risk of a crash.

When the recalled bed rails are attached to an adult's bed, users can become entrapped within the bed rail or between the bed rail and the side of the mattress. This poses a serious entrapment hazard and risk of death by asphyxiation.

After alerting consumers to the presence of natural gas or carbon monoxide, the recalled alarm can go into sleep mode when the alert lasts less than four minutes. During this time, the alarms can fail to detect and alert consumers to a new incidence of natural gas or carbon monoxide, posing a risk of carbon monoxide poisoning.

The parking brake on the recalled strollers can disengage, posing an injury hazard.

The crank can break, due to fatigue fractures, causing the rider to lose control, posing fall and crash hazards.

The recalled planter box frame can break, posing an injury hazard.

The brown paint on the exterior of the recalled Christmas tree ornaments did not fully dry before packaging, causing mold to grow on the exterior surface of the ornament, posing risk of respiratory issues to consumers due to mold exposure.